Toyota Tundra 2005 Service - Repair - Maintenance page 2503

SUSPENSION AND AXLE
REMOVAL
1. DISCONNECT STABILIZER BAR LINKS
Remove the 2 nuts and disconnect the stabilizer bar links from
the lower suspension arms.
HINT:
If the ball joint turns together with the nut, use a hexagon (6 mm)
wrench to hold the stud.
W01738
2. REMOVE STABILIZER BAR
(a) Remove the 2 bolts, nuts and stabilizer bar with the cush-
ions and brackets.
(b) Remove the 2 brackets and cushions from the stabilizer
bar.
F07266
3. REMOVE STABILIZER BAR LINKS
(a) Hold the stabilizer bar link, and remove the nut.
(b) Remove the stabilizer bar link, 2 retainers and bushings
from the stabilizer bar.
(c) Use the same procedures described above to the other
side.
R12778
− FRONT STABILIZER BAR
SA−89
SA0B5−04