Toyota Tundra 2005 Service - Repair - Maintenance page 2754

SR-76
SST
Matchmarks
Vinyl Tape
Shop Rag
STEERING
8. REMOVE RACK HOUSING CAP
Using SST, remove the rack housing cap.
SST
SST
F06753
9. REMOVE SELF-SOCKING NUT
Using SST to stop the control valve shaft rotating, remove the
nut.
SST
10. REMOVE DUST COVER
F06754
11. REMOVE CONTROL VALVE HOUSING WITH CON-
TROL VALVE ASSEMBLY
(a) Put matchmarks on the control valve housing and rack
housing.
(b) Remove the 2 bolts and control valve housing with control
valve assembly.
(c) Remove the gasket from the rack housing.
F06755
12. REMOVE CONTROL VALVE ASSEMBLY
(a) To prevent oil seal lip damage, wind vinyl tape on the ser-
rated part of the valve shaft.
(b) Press out the valve assembly with the oil seal.
NOTICE:
L
Place a shop rag between the valve housing and the
blocks.
L
Be careful not to drop the valve assembly.
L
Be careful not to damage the oil seal lip.
F06756
13. REMOVE OIL SEAL
Remove the oil seal from the control valve assembly.
- POWER STEERING GEAR
09816-30010
09616-0001 1
Author : Date :
4402