Toyota Tundra 2005 Service - Repair - Maintenance page 2553

Hide thumbs Also See for Tundra 2005:

Table of Contents

SUSPENSION AND AXLE

REAR DIFFERENTIAL CARRIER (w/ LSD)

INSPECT RING GEAR RUNOUT

Install the differential case into the carrier and install the

plate washers to where there is no play in the bearing

(See step 12.).

Install the bearing cap (See step 15.).

Using a dial indicator, measure the runout of the ring gear.

Remove the bearing caps and differential case.

Maximum runout: 0.05 mm (0.0020 in.)

INSTALL DRIVE PINION BEARING OUTER RACES

AND ADJUSTING WASHER

Using SST and a press, install a new front bearing outer

race to the carrier.

09950−60020 (09951−00710),

09950−70010 (09951−07150)

Using SST and a press, install a new adjusting washer

and a new rear bearing outer race to the carrier.

09950−60020 (09951−00910),

09950−70010 (09951−07150)

First fit a washer with the same thickness as the washer which

was removed, then after checking the tooth contact pattern, re-

place the washer with a different thickness if necessary.

INSTALL DRIVE PINION REAR BEARING

Using SST and a press, install the rear bearing onto the drive

TEMPORARILY ADJUST DRIVE PINION PRELOAD

Install the drive pinion and front bearing.

After adjusting the ring gear tooth contact pattern, assemble the

spacer, washers and oil seal.