Toyota Tundra 2005 Service - Repair - Maintenance page 3103

Hide thumbs Also See for Tundra 2005:

Table of Contents

BODY ELECTRICAL

GARAGE DOOR OPENER SYSTEM

(Double Cab)

REGISTRATION PROCEDURE

The vehicle's garage door opener records transmitter codes for

systems such as garage doors, gates, entry gates, door locks,

home lighting systems, security systems or other transmitter

code based systems. The garage door opener is built into the

roof console box assembly. After the console box assembly is

replaced, transmitter codes for any systems previously regis-

tered in the garage door opener must be re-registered.

Re-register systems in the garage door opener registra-

Do not perform transmitter code registration for a

system if people or objects are near the system to be

registered. When registering transmitter codes, inju-

ry or damage can occur as the system may open,

close, unlock or otherwise operate.

Before transmitter code registration, stop the engine

and remove the key from the ignition switch.

The garage door opener cannot be used with: 1) sys-

tems that: 1) were manufactured before April 1, 1982;

or 2) systems that do not meet Federal Safety Stan-

dards (for example, garage doors without a jam

protection function).

3 transmitter codes can be registered with the garage

door opener, one transmitter code for each of the 3 ga-

rage door opener switches.

Disconnecting the battery will not erase the transmitter

codes registered with the garage door opener.

An attempt to overwrite a previously registered transmit-

ter code with a new system's transmitter code may fail. In

these situations, the previously registered transmitter

code will not be erased.

GARAGE DOOR OPENER SYSTEM (Double Cab)