Toyota Tundra 2005 Service - Repair - Maintenance page 3192

BO-78
a
a
b
b
c
c
a - a
B
c - c
A
B
b - b
A A
B
H11390
BO2821
N08495
H11338
BODY - WINDSHIELD
(b) Load the cartridge into the sealer gun.
(c) Coat the glass with adhesive as shown in the illustration.
A: 12 mm (0.47 in.)
B: 8 mm (0.31 in.)
11. INSTALL WINDSHIELD GLASS AND MOULDING
(a) Install the glass, aligning the reference marks using a suc-
tion rubber.
HINT:
Check that stoppers engage correctly viewing.
(b) Lightly press the glass front surface for close contact.
(c) Correct insufficient or protruded adhesive agent using a
spatula.
HINT:
Apply the adhesive agent up to the windshield glass edge.
(d) Install a new windshield outside upper moulding to the
windshield glass before the adhesive agent hardens.
HINT:
Install the moulding, aligning the center of moulding with the
center of body.
(e) Using a scraper, remove any excessive adhesive agent
before it hardens.
(f) Hold the glass and moulding in place securely with a pro-
tective tape or equivalent until the adhesive hardened.
Author : Date :
4849