Toyota Tundra 2005 Service - Repair - Maintenance page 2434

SA−20
SUSPENSION AND AXLE
REMOVAL
1. REMOVE FRONT WHEEL
2. REMOVE GREASE CAP
Using a screwdriver and hammer, remove the grease cap.
3. INSPECT FRONT AXLE HUB BEARING
(a) Remove the front disc brake caliper.
(b) Remove the front disc.
(c) Inspect the axle hub backlash.
(1)
Maximum: 0.05 mm (0.0020 in.)
If the backlash exceeds the maximum, replace the bearing.
cmc0311
(d) Inspect the axle hub deviation.
(1)
Maximum: 0.05 mm (0.0020 in.)
If the deviation exceeds the maximum, replace the bearing.
(e) Install the front disc.
(f) Install the front disc brake caliper.
(1)
Torque: 123 N m (1,250 kgf cm, 90 ft lbf)
cmc0312
4. 4WD:
DISCONNECT DRIVE SHAFT
(a) Remove the cotter pin and lock cap.
(b) While applying the brakes, remove the lock nut.
R13426
5. w/ ABS:
DISCONNECT ABS SPEED SENSOR AND WIRE HAR-
NESS CLAMP FROM STEERING KNUCKLE
Remove the 2 bolts and disconnect the ABS speed sensor and
wire harness clamp from the steering knuckle.
F07263
− FRONT AXLE HUB
Using a dial indicator, check the backlash near the
center of the axle hub.
Using a dial indicator, check the deviation at the sur-
face of the axle hub.
Install the brake caliper and 2 bolts.
SA1JZ−02