Toyota Tundra 2005 Service - Repair - Maintenance page 3337

H23460
H17260
Hook
H23459
BODY - REAR SEAT (RH)
DISASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:
z
Tape the screwdriver tip before using it to remove the
parts.
z
A bolt without a torque specification is shown in the stan-
dard bolt chart (see page
1. REMOVE HEADREST
2. REMOVE RECLINING ADJUSTER RELEASE HANDLE
(a) Remove the screw and release handle.
3. REMOVE NO. 1 REAR SEAT RECLINING COVER RH
(a) Remove the screw and No. 1 rear seat reclining cover.
4. REMOVE NO. 1 REAR SEAT RECLINING COVER LH
(a) Remove the screw and No. 1 rear seat reclining cover.
5. REMOVE SEATBACK ASSEMBLY
(a) Tilting the seat forward.
(b) As shown in the illustration, disengage the hook and open
the seatback cover.
(c) Remove the 4 bolts and the seatback assembly.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
6. REMOVE SEATBACK COVER
(a) Remove the headrest supports.
(b) Disengage the hooks, and remove the seatback frame
from the seatback cover with pad.
Author :
SS-2 ).
Date :
BO-223
BO4RA-02
4994