Toyota Tundra 2005 Service - Repair - Maintenance page 2970

DOOR
1
Released
Pushed
BODY ELECTRICAL
INSPECTION
1.
1
(a)
3
(b)
I11933
(c)
2
If the result is not as specified, replace the bulb or light.
3
I03096
2.
(a)
(b)
2
N08313
(c)
If the result is not as specified, replace the bulb or light.
2
N08314
3.
(a)
Ohmmeter
(b)
If the result is not as specified, replace the switch.
N20159
- INTERIOR LIGHT SYSTEM (Except Double Cab)
INSPECT FRONT PERSONAL LIGHT CONTINUITY
Disconnect the connector from the personal light.
Push the personal light switch ON, check that continuity
exists between terminals 3 and 1.
Turn the light switch to the DOOR position, check that
continuity exists between terminals 2 and 3.
INSPECT ROOM LIGHT CONTINUITY
Disconnect the connector from the light.
Turn the interior light switch ON, check that continuity ex-
ists between terminal 2 and body ground.
Turn the light switch to the DOOR position, check that
continuity exists between terminals 1 and 2.
INSPECT (FRONT) DOOR COURTESY SWITCH CON-
TINUITY
Check that continuity exists between the terminal and the
switch body with the switch ON (switch pin released: door
opened).
Check that no continuity exists between terminals and the
switch body with the switch OFF (switch pin pushed in:
door closed).
Author :
BE-61
BE2KB-01
Date :
4618