Toyota Tundra 2005 Service - Repair - Maintenance page 3003

BE-94
Warning Light
Ignition
Switch
Battery
OFF
ON
Warning Light
Ignition
Switch
Battery
3
3 2
BODY ELECTRICAL
21.
(a)
(b)
(c)
If the warning light does not turn on, inspect the bulb.
BE1217
22.
(a)
(b)
If the continuity is not as specified, replace the switch.
N07797
23.
(a)
(b)
(c)
If the warning light does not light up, inspect the bulb or wire har-
ness.
BE0044
24.
(a)
13
(b)
If the continuity is not as specified, replace the inner seat belt.
I28682
25.
(a)
(b)
If the continuity is not as specified, replace the inner seat belt.
I28683
- COMBINATION METER
INSPECT WASHER LEVEL WARNING LIGHT
Disconnect the connectors from the level warning switch.
Connect the terminals of the wire harness side of the level
warning switch connector.
Turn the ignition switch ON, and check that the warning
light turns on.
INSPECT WASHER LEVEL SWITCH CONTINUITY
Check that there is no continuity between the terminals
with the switch OFF (float).
Check that there is continuity between the terminals with
the switch ON (sink).
INSPECT DRIVER'S SEAT BELT WARNING LIGHT
Disconnect connector B from the combination meter.
Connect the negative (-) lead from the battery to terminal
9.
Turn the ignition switch ON and check that the warning
light lights up.
Except regular cab (w/o Power seat (Driver side):
INSPECT BUCKLE SWITCH CONTINUITY
Check that continuity exists between terminals 3 and 13
of the switch connector with the switch ON (belt fastened).
Check that no continuity exists between terminals 3 and
13 on the switch side connector with the switch OFF (belt
unfastened).
Except regular cab (w/ Power seat (Driver side):
INSPECT BUCKLE SWITCH CONTINUITY
Check that continuity exists between terminals 2 and 3 on
the switch side connector with the switch ON (belt fas-
tened).
Check that no continuity exists between terminals 2 and
3 on the switch side connector with the switch OFF (belt
unfastened).
Author : Date :
4651