Toyota Tundra 2005 Service - Repair - Maintenance page 2718

Hide thumbs Also See for Tundra 2005:

Table of Contents

Retaining Ring

When using a vise, do not overtighten it.

Install the tilt lever with a new tilt lever lock shaft.

Do not bend the universal joint of the shaft assembly more

Hold the main shaft assembly with your hand to prevent rota-

STEERING COLUMN (Double Cab)

COAT PARTS INDICATED BY ARROWS WITH MOLYB-

DENUM DISULFIDE LITHIUM BASE GREASE (See

INSTALL TILT LEVER

Torque: 9.0 N·m (90 kgf·cm, 78 in.·lbf)

INSTALL MAIN SHAFT ASSEMBLY

Install the inner race, upper bearing inner race seat, com-

pression spring and spring retainer.

Install a new No. 2 steering column ring to the main shaft

Install the washer of SST on the main shaft assembly.

Set SST on the main shaft assembly, as shown in the il-

Using SST, push down the retaining ring until it fits into the

shaft groove and install the main shaft assembly.

INSTALL MAIN SHAFT STOPPER

INSTALL 2 NEW TILT NO. 1 STOPPERS

INSTALL STEERING COLUMN HOUSING WITH MAIN

SHAFT ASSEMBLY

Install the steering column housing with the main shaft as-

sembly into the column tube assembly.

Install the tilt spring and spring guide.

Hold the steering column housing and steering column

housing support in a vise.

Temporarily install 2 new pivot pins.