Toyota Tundra 2005 Service - Repair - Maintenance page 2542

SA−128
SST
Front
SUSPENSION AND AXLE
Matchmarks
F16244
SST
F16245
FA1111
Rear
R04326
− REAR DIFFERENTIAL CARRIER (w/ LSD)
10. REMOVE DIFFERENTIAL CASE
(a) Place matchmarks on the bearing cap and differential car-
rier.
(b) Remove the 4 bolts and bearing cap.
(c) Using SST and a plastic hammer, remove the 2 side bear-
ing plate washers.
SST 09504−22012
HINT:
Measure the plate washer thickness and note it down.
(d) Remove the differential case with the bearing outer races
from the carrier.
HINT:
Tag the disassembled parts to show the location for reassem-
bling.
11. REMOVE DRIVE PINION FROM DIFFERENTIAL CAR-
RIER
Remove the drive pinion with the rear bearing.
12. REMOVE DRIVE PINION REAR BEARING
Using SST and a press, remove the bearing from the drive pin-
ion.
SST 09950−00020
HINT:
If the drive pinion or ring gear is damaged, replace them as a
set.
13. REMOVE FRONT AND REAR BEARING OUTER
RACES AND ADJUST WASHER
NOTICE:
Do not remove the outer races except when replacing the
bearings.
Using a brass bar and hammer, remove the outer races and ad-
justing washer from the carrier.
HINT:
Measure the adjusting washer thickness and note it down.