Toyota Tundra 2005 Service - Repair - Maintenance page 2584

BR−8
F19548
F19548
BRAKE
(d) Bleed rear brake line.
(1)
HINT:
Pump operating sound can be heard.
(2)
(3)
HINT:
F19832
Brake fluid is pumped out automatically.
NOTICE:
Keep brake fluid in the reservoir tank above the MIN line
during the above procedures.
(4)
Torque: (Bleeder plug) 11 N·m (110 kgf·cm, 8 ft·lbf)
(5)
(e) Hydraulic brake booster disassembly:
Bleed hydraulic brake booster.
NOTICE:
When disassembling the hydraulic brake booster, bleed
the air from the hydraulic brake booster by following the
procedures below.
Hand−held
(1)
Tester
(2)
HINT:
D05981
S
Pump operating sound can be heard.
S
Please refer to the hand−held tester operator's manual
for further details.
(3)
(4)
(5)
(6)
NOTICE:
S
Do not depress the brake pedal.
S
Keep brake fluid in the reservoir tank above the MIN
line during the above procedures.
F19833
− BRAKE FLUID
Turn the ignition switch to the ON position and wait
until the pump motor has stopped.
Connect the vinyl tube to the wheel cylinder.
Depress the brake pedal, hold it, and then loosen
the bleeder plug.
When air does not come out with brake fluid any-
more, tighten the bleeder plug and release the
brake pedal.
Repeat the above procedures for each wheel to
bleed the air out of the brake line .
Connect the hand−held tester to the DLC3.
Turn the ignition switch to the ON position.
Select "ACTIVE TEST" mode on the hand−held tes-
ter.
Connect the vinyl tube to the rear wheel cylinder.
Loosen the bleeder plug
Select "SRMF & SRMR" on the "ACTIVE TEST" of
the hand−held tester to drive solenoids.