Toyota Tundra 2005 Service - Repair - Maintenance page 2484

SA−70
SST
SUSPENSION AND AXLE
REMOVAL
1. REMOVE SHOCK ABSORBER WITH COIL SPRING
(See page SA−63)
2. w/ ABS:
DISCONNECT ABS SPEED SENSOR WIRE HARNESS
CLAMPS
Remove the 2 bolts and ABS speed sensor wire harness
clamps from the steering knuckle and upper suspension arm.
3. DISCONNECT UPPER BALL JOINT
(a) Remove the cotter pin and loosen the nut.
(b) Using SST, disconnect the upper ball joint.
SST
(c) Support the steering knuckle securely.
(d) Remove the nut.
4. REMOVE REAR FENDER APRON SEAL
Remove the 4 clips and rear fender apron seal.
R13196
5. REMOVE BRAKE AND FUEL LINE CLAMP
Disengage the 2 brake lines and fuel line, and remove the nut
and brake line clamp.
F07269
6. REMOVE UPPER SUSPENSION ARM
Remove the nut, bolt, 2 washers and upper suspension arm.
F07270
− FRONT UPPER SUSPENSION ARM
09950−40011 (09951−04010, 09952−04010,
09953−04020, 09954−04010, 09955−04031,
09958−04011)
SA1K6−03