Toyota Tundra 2005 Service - Repair - Maintenance page 2512

SA−98
SST
SUSPENSION AND AXLE
INSTALLATION
1. INSTALL NEW O−RING TO REAR AXLE HOUSING
2. INSTALL REAR AXLE SHAFT ASSEMBLY
Torque: 69 N·m (700 kgf·cm, 51 ft·lbf)
3. CONNECT BRAKE LINE AND PARKING BRAKE
CABLE
(a) Connect the parking brake cable with the pin and clip.
(b) Using SST, connect the brake line to the wheel cylinder.
SST
SST
Torque: 15 N·m (155 kgf·cm, 11 ft·lbf)
4. INSTALL REAR BRAKE ASSEMBLY (See page
BR−52)
5. w/ ABS:
INSTALL ABS SPEED SENSOR
Torque: 8.0 N·m (82 kgf·cm, 71 ft·lbf)
6. CHECK BEARING BACKLASH AND AXLE SHAFT
F06623
DEVIATION (See page SA−93)
7. INSTALL NEW GASKET AND BRAKE DRUM
8. INSTALL REAR WHEEL
Torque: 110 N·m (1,150 kgf·cm, 83 ft·lbf)
9. BLEED BRAKE SYSTEM (See page BR−4)
10. w/ ABS:
CHECK ABS SPEED SENSOR SIGNAL (See page
DI−1387
− REAR AXLE SHAFT
09023−00101
or DI−1478)
SA1KC−03