Toyota Tundra 2005 Service - Repair - Maintenance page 2435

SST
SUSPENSION AND AXLE
6. REMOVE BRAKE CALIPER AND DISC
(a) Remove the bolt and brake line clamp from the steering
knuckle.
(b) Remove the 2 bolts, brake caliper and disc.
NOTICE:
Do not damage the brake tube.
(c) Support the brake caliper securely.
7. REMOVE SHOCK ABSORBER (See page SA−63)
F07264
8. DISCONNECT LOWER BALL JOINT WITH LOWER
BALL JOINT DUST COVER PROTECTOR
Remove the 4 bolts and disconnect the lower ball joint with low-
er ball joint dust cover protector.
9. REMOVE STEERING KNUCKLE
(a) Remove the cotter pin and loosen the nut.
F07265
(b) Using SST, disconnect the steering knuckle.
SST
(c) Remove the nut and steering knuckle.
NOTICE:
4WD:
Be careful not to damage the oil seal and drive shaft boot.
HINT:
R13196
4WD:
When it is difficult to disconnect the drive shaft, tap the tip of the
drive shaft with a plastic hammer.
− FRONT AXLE HUB
09950−40011 (09951−04010, 09952−04010,
09553−04020, 09554−04010, 09955−04031,
09958−04011)
SA−21