Toyota Tundra 2005 Service - Repair - Maintenance page 3348

BO-234
15°
BODY
INSPECTION
CAUTION:
Replace the seat belt assembly (outer belt, inner belt, bolts,
nuts or sill-bar) if it has been used in a severe impact. The
entire assembly should be replaced even if damage is not
obvious.
1. Except manual type:
CONDUCT RUNNING TEST (IN SAFE AREA)
(a) Fasten the front seat belts.
(b) Drive the vehicle at 16 km/h (10 mph) and brake hard.
Check that the belt locks and cannot be extended at this
time.
HINT:
Conduct this test in a safe area. If the belt does not lock, remove
the belt mechanism assembly and conduct the following static
check. Also, whenever installing a new belt assembly, verify the
proper operation before installation.
2. Driver seat belt (ELR):
BO0632
STATIC TEST
(a) Make sure that the belt locks when pulled out quickly.
(b) Remove the locking retractor assembly.
(c) Tilt the retractor slowly.
(d) Make sure that the belt can be pulled out at a tilt of 15 de-
grees or less, and cannot be pulled out over 45 degrees.
45°
If a problem is found, replace the assembly.
3. Except driver seat belt (ALR/ELR):
STATIC TEST
(a) Make sure that the belt locks when pulled out quickly.
(b) Pull out the whole belt, then retract the belt slightly and
pull it out again
(c) Make sure that the belt cannot be extended further.
BO0633
If a problem is found, replace the assembly.
(d) Remove the locking retractor assembly.
HINT:
Front passenger's seat belt only:
Before removing the pretensioner connector, be sure to read
the precautionary notice in the RS section.
(e) Tilt the retractor slowly.
- SEAT BELT
Author :
BO4T2-01
Date :
5005