Toyota Tundra 2005 Service - Repair - Maintenance page 2701

SST
Shaft Bearing
STEERING - STEERING COLUMN (Standard Cab, Access Cab)
INSPECTION
1. INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.
F02583
2. IF NECESSARY, REPLACE KEY CYLINDER
(a) Place the ignition key in the ACC position.
(b) Push down the stop pin with a screwdriver, and pull out
the cylinder.
(c) Install a new cylinder.
HINT:
Make sure the key is in the ACC position.
3. INSPECT IGNITION SWITCH (See page
4. IF NECESSARY, REPLACE IGNITION SWITCH
F02584
(a) Remove the 2 screws and ignition switch.
(b) Install a new ignition switch with the 2 screws.
5. INSPECT KEY UNLOCK WARNING SWITCH
(See page
6. IF NECESSARY, REPLACE KEY UNLOCK WARNING
SWITCH
(a) Slide out the key unlock warning switch.
(b) Install a new key unlock warning switch.
7. A/T:
INSPECT BEARING
(a) Check that the bearing rotates smoothly without abnor-
mal noise.
If it does not rotate smoothly or abnormal noise occurs, replace
the column housing.
(b) Coat the bearing with molybdenum disulfide lithium base
grease.
R11908
8. IF NECESSARY, REPLACE SHAFT BEARING
(a) Using SST and a press, press out the shaft bearing.
SST 09950-60010 (09951-00430),
09950-70010 (09951-07360)
F14452
BE-37 )
Author : Date :
SR-23
SR1KJ-02
BE-37 )
4349