Toyota Tundra 2005 Service - Repair - Maintenance page 2808

SUPPLEMENTAL RESTRAINT SYSTEM
SST
- FRONT PASSENGER AIRBAG ASSEMBLY
(h) Deploy the airbag.
(1) Check that no one is inside the vehicle or within a
10 m (33 ft) radius of the vehicle.
(2) Press the SST activation switch and deploy the air-
bag.
CAUTION:
z
When deploying the airbag, make sure that no one is
near the vehicle.
z
The front passenger airbag assembly becomes ex-
tremely hot when the airbag is deployed, so do not
touch it for at least 30 minutes after deployment.
z
Use gloves and safety glasses when handling a front
passenger airbag assembly with a deployed airbag.
z
Do not apply water, etc. to a front passenger airbag
assembly with a deployed airbag.
z
Always wash your hands with water after completing
the operation.
HINT:
The airbag deploys as the LED of the SST activation switch
comes on.
2. DEPLOYMENT WHEN DISPOSING OF FRONT PAS-
SENGER AIRBAG ASSEMBLY ONLY
NOTICE:
z
When disposing of the front passenger airbag assem-
bly, never use the customer's vehicle to deploy the
airbag.
z
Be sure to follow the procedure detailed below when
deploying the airbag.
HINT:
Prepare a battery as the power source to deploy the airbag.
(a) Check the function of the SST (see step 1-(a)).
AB0152
(b) Remove the front passenger airbag assembly (see page
RS-36 ).
CAUTION:
z
When removing the front passenger airbag assembly,
work must be started 90 seconds after the ignition
switch is turned to the "LOCK" position and the nega-
tive (-) terminal cable is disconnected from the bat-
tery.
z
When storing the front passenger airbag assembly,
H23213
keep the airbag deployment side facing upward.
Author : Date :
RS-41
4456