Toyota Tundra 2005 Service - Repair - Maintenance page 2847

RS-80
SUPPLEMENTAL RESTRAINT SYSTEM
Torx® Screw
- SIDE AIRBAG ASSEMBLY (Passenger Side of Split
Type)
INSTALLATION
HINT:
z
Use the same procedures for the RH side and LH side.
z
The procedures listed below are for the LH side.
NOTICE:
z
If the side airbag assembly has been dropped, or
there are cracks, dents or other defects in the case or
connector, replace the side airbag assembly with a
new one.
z
When installing the side airbag assembly, take care
it is not pinched between other parts.
z
Never use airbag parts from another vehicle. When
replacing parts, replace them with new ones.
1. INSTALL SEATBACK ASSEMBLY
(a) Install the bushing to the seatback frame.
(b) Using a torx® socket wrench, install the seatback assem-
bly with the 2 torx® screws to the seat cushion assembly.
Torque: 42 N·m (428 kgf·cm, 31 ft·lbf)
(c) Install the 3 bolts.
Torque:
Bolt A: 55 N·m (561 kgf·cm, 41 ft·lbf)
Bolt B: 21 N·m (214 kgf·cm, 15 ft·lbf)
(d) Connect the front seat center belt with the 3 nuts.
(e) Install the RH reclining adjuster inside cover with the 2
screws.
(f) Install the RH seat cushion lower shield with the screw.
H24359
Bolt "A"
Bolt "B"
Author : Date :
RS12N-01
H24360
4495