Toyota Tundra 2005 Service - Repair - Maintenance page 3021

BE-1 12
2
2
BODY ELECTRICAL
1
I27175
2 1
I27176
1
I27177
- POWER WINDOW CONTROL SYSTEM (Double Cab)
(d) Continue to apply voltage and check that the current
changes from approximately 14 A to less than 1 A within
4 to 90 seconds.
(e) Disconnect the leads from the terminals.
(f) Approximately 90 seconds later, connect the positive (+)
lead from the battery to terminal 1 and the negative (-)
lead to terminal 2, then check that the window begins to
move down.
If operation is not as specified, replace the motor.
10. Rear right door:
INSPECT POWER WINDOW MOTOR PTC THERM-
ISTOR OPERATION
(a) Disconnect the connector from the motor.
(b) Connect the negative (+) lead from the ammeter to termi-
nal 2 of the motor connector and the negative (-) lead to
negative terminal of the battery.
(c) Connect the positive (+) lead from the battery to terminal
1 of the motor connector, and raise the window to the fully
closed position.
(d) Continue to apply voltage and check that the current
changes from approximately 14 A to less than 1 A within
4 to 90 seconds.
(e) Disconnect the leads from the terminals.
(f) Approximately 90 seconds later, connect the positive (+)
lead from the battery to terminal 2 and the negative (-)
lead to terminal 1, check that the window begins to move
down.
If operation is not as specified, replace the motor.
Author : Date :
4669