Combination Meter Assy:
A-32
417.792ms 2
BODY ELECTRICAL
-
COMBINATION METER
12.
INSPECT INPUT ENGINE COOLANT TEMPERATURE
SIGNAL WAVEFORM
(a)
Remove the combination meter with connectors still con-
nected.
(b)
Connect the oscilloscope to terminal A32 and body
ground.
(c)
Start the engine.
I28306
(d)
Check the signal waveform according to the condition(s)
in the table below.
Tool setting
Vehicle condition
GND
OK:
As shown in the illustration
I28906
13.
INSPECT ENGINE COOLANT TEMPERATURE SEND-
ER GAUGE RESISTANCE
(a)
Disconnect the connector from the engine coolant tem-
perature sender gauge.
(b)
Measure the resistance according to the value(s) in the
table below.
Temperature °C (°F)
I28689
110 (230)
If the resistance value is not as specified, replace the sender
gauge.
Item
-20 (-4)
20 (68)
80 (176)
Author :
BE-91
Condition
5 V/DIV, 10 ms/DIV
Ignition switch ACC or ON
Resistance (kΩ)
13.54 to 16.63
2.28 to 2.63
0.31 to 0.33
0.13 to 0.15
Date :
4648