Toyota Tundra 2005 Service - Repair - Maintenance page 2470

SA−56
Adhesive
SUSPENSION AND AXLE
29. INSTALL CLUTCH CASE TO DIFFERENTIAL TUBE
(a) Install a new O−ring to the tube.
(b) Coat the O−ring with MP grease.
(c) Install the clutch case to the tube.
(d) Using a torx® socket (E14), torque the 2 torx® bolts.
Torque: 78 N·m (800 kgf·cm, 58 ft·lbf)
30. INSTALL CLUTCH SLEEVE
31. INSTALL DIFFERENTIAL TUBE TO DIFFERENTIAL
(a) Remove any old FIPG material and be careful not to drop
SA0371
oil on the contact surfaces of the differential and clutch
case.
(b) Clean both installation surfaces of loose FIPG and oil ma-
terial with gasoline or alcohol.
(c) Apply FIPG to the differential, as shown in the illustration.
FIPG:
FIPG
Part No. 08826−00090, THREE BOND 1281 or
equivalent
HINT:
Install the differential tube within 10 minutes after applying
FIPG.
(d) Install the differential tube to the differential.
(e) Clean the threads of the 2 long torx® bolts and retainer
R13201
bolt holes with toluene or trichlorethylene.
(f) Apply adhesive to 2 or 3 threads of the long bolts end.
Adhesive:
Part No. 08833−00070, THREE BOND 1324 or equiva-
lent
(g) Using torx® socket (E14), torque the 4 torx® bolts.
Torque: 78 N·m (800 kgf·cm, 58 ft·lbf)
32. INSTALL A.D.D. ACTUATOR
(a) Remove any old FIPG material and be careful not to drop
oil on the contact surfaces of the actuator and clutch case.
F07258
(b) Clean both installation surfaces of loose FIPG and oil ma-
terial with gasoline or alcohol.
− FRONT DIFFERENTIAL CARRIER