Toyota Tundra 2005 Service - Repair - Maintenance page 2510

Hide thumbs Also See for Tundra 2005:

Table of Contents

122.2 ± 1.0 mm

(4.811 ± 0.039 in.)

SUSPENSION AND AXLE

Socket Wrench

Bearing Side

REAR AXLE SHAFT

Position the backing plate on a new bearing case and us-

ing 2 socket wrenches and a press, install the serration

Install a new bearing (See step 6.).

Install a new outer side oil seal (See step 7.).

REPLACE OIL DEFLECTOR

Using a brass bar and hammer, remove the hub bolts, oil

deflector and gasket.

Position a new gasket and oil deflector on the axle shaft

and install a washer and nut to the hub bolt and install the

hub bolt by torquing the nut.

Remove the nut and washer.

INSTALL REAR AXLE SHAFT IN BACKING PLATE

Coat the new outer side oil seal lip with MP grease.

Install the backing plate and bearing retainer on the rear

Using SST and a press, install the rear axle shaft into the

backing plate.

09316−60011 (09316−00051)

Using a snap ring expander, install a new snap ring.

INSTALL ABS SPEED SENSOR ROTOR AND BEAR-

ING RETAINER (DIFFERENTIAL SIDE)

Using SST and a press, install a new sensor rotor and new bear-

ing retainer to the axle shaft.

09316−60011 (09316−00051)

Standard length: 122.2 ± 1.0 mm (4.811 ± 0.039 in.)

REPLACE OIL SEAL (INNER SIDE)

Using SST, remove the oil seal.