Toyota Tundra 2005 Service - Repair - Maintenance page 3207

Hide thumbs Also See for Tundra 2005:

Table of Contents

BACK WINDOW GLASS

Confirm that the moulding is attached to the body panel as

shown in the illustration.

Hold the back window glass in place securely with a pro-

tective tape or equivalent until the adhesive hardens.

Take care not to drive the vehicle during the time described

in the table below.

Usage timeframe:

35 °C (95 °F)

20 °C (68 °F)

5 °C (41 °F)

INSPECT FOR LEAK AND REPAIR

Conduct a leak test after the adhesive has completely hard-

Adhesive: Part No. 08833-00030 or equivalent

Power vertical type:

INSTALL BACK WINDOW MOULDING

Using a hand riveter or an air riveter, install the 14 drive

pulley assemblies.

Do not prize the riveter. The riveter will be damaged and the

mandrel will bend.

Do not tilt the riveter when fastening the rivet to the

item(s) as this will cause the rivet to be loose.

Do not have any space between the rivet head and the

item(s). The rivet head must be completely flat

against the item(s).

Usage Timeframe