Toyota Tundra 2005 Service - Repair - Maintenance page 2440

SA−26
INSTALLATION
1. INSTALL STEERING KNUCKLE
(a) 4WD:
Insert the drive shaft into the axle hub and temporarily tighten the nut.
NOTICE:
Be careful not to damage the oil seal and drive shaft boot.
(b) Connect the steering knuckle to the upper suspension arm.
(c) Install the nut and a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
Torque: 105 N·m (1,100 kgf·cm, 77 ft·lbf)
2. CONNECT LOWER BALL JOINT WITH LOWER BALL JOINT DUST COVER PROTECTOR
Connect the lower ball joint with lower ball joint dust cover protector to the steering knuckle with the 4 bolts.
Torque: 65 N·m (662 kgf·cm, 48 ft·lbf)
3. INSTALL SHOCK ABSORBER (See page SA−68)
4. INSTALL BRAKE CALIPER
(a) Install the disc, brake caliper and 2 bolts.
Torque: 123 N·m (1,250 kgf·cm, 90 ft·lbf)
(b) Install the brake line clamp to the steering knuckle with the bolt.
Torque: 28 N·m (285 kgf·cm, 21 ft·lbf)
5. w/ ABS:
CONNECT ABS SPEED SENSOR AND WIRE HARNESS CLAMP
Connect the ABS speed sensor and wire harness clamp to the steering knuckle with the 2 bolts.
Torque: 8.0 N·m (82 kgf·cm, 71 ft·lbf)
6. 4WD:
INSTALL DRIVE SHAFT LOCK NUT
(a) While applying the brakes, tighten the nut.
Torque: 235 N·m (2,400 kgf·cm, 173 ft·lbf)
(b) Install the lock cap and a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
7. INSTALL GREASE CAP
8. INSTALL FRONT WHEEL
Torque: 110 N·m (1,150 kgf·cm, 83 ft·lbf)
9. DEPRESS BRAKE PEDAL SEVERAL TIMES
10. CHECK FRONT WHEEL ALIGNMENT (See page SA−5)
11. CHECK ABS SPEED SENSOR SIGNAL (See page
SUSPENSION AND AXLE − FRONT AXLE HUB
DI−1387 or DI−1478)
SA1G6−03