Toyota Tundra 2005 Service - Repair - Maintenance page 3259

Hide thumbs Also See for Tundra 2005:

Table of Contents

FRONT SEAT (Separate Type: Power Adjuster)

Remove the hog rings from the seat cushion cover.

Unlatch the seat cushion cover hooks, then remove the

seat cushion cover and seat cushion pad.

REMOVE SEAT CUSHION COVER

Remove the hog rings and seat cushion cover from the seat

cushion pad.

w/ Seat heater:

REMOVE SEAT CUSHION HEATER ASSEMBLY

Cut off the tack pins which fasten the seat heater, and then re-

move the seat cushion heater assembly from the seat cushion

REMOVE LUMBAR SUPPORT ADJUSTER

Disconnect the connector.

Disengage the seatback spring edge from the seat frame

Be careful when releasing the seatback spring edge, be-

cause there is a possibility that the spring may break due

to tension by the lumbar support.

Remove the 2 screws and lumbar support adjuster.

Remove the bushing from the lumbar support adjuster.

REMOVE RH AND LH RECLINING ADJUSTER INSIDE

Remove the screw and RH reclining adjuster inside cover.

Disconnect the wire harness clamp.

Perform the same procedure on the other side.