Toyota Tundra 2005 Service - Repair - Maintenance page 2523

SST
SST
SUSPENSION AND AXLE
10.
(a)
If the front bearing is damaged or worn, replace the front bear-
ing.
(b)
Z00641
11.
(a)
Matchmarks
(b)
R04324
(c)
SST
HINT:
Measure the plate washer thickness and note it down.
(d)
HINT:
Tag the bearing outer races to show the location for reassem-
R04325
bling.
12.
Remove the drive pinion with the rear bearing.
13.
Using SST and a press, remove the bearing from the drive pin-
ion.
HINT:
If the drive pinion or ring gear is damaged, replace them as a
set.
R02482
− REAR DIFFERENTIAL CARRIER
REMOVE FRONT BEARING AND BEARING SPACER
Using SST, remove the bearing from the drive pinion.
SST 09556−22010
Remove the 2 washers and bearing spacer.
REMOVE DIFFERENTIAL CASE
Place matchmarks on the bearing cap and differential car-
rier.
Remove the 4 bolts and bearing cap.
Using SST and a plastic hammer, remove the 2 side bear-
ing plate washers.
SST 09504−22012
Remove the differential case with the bearing outer races
from the carrier.
REMOVE DRIVE PINION FROM DIFFERENTIAL CAR-
RIER
REMOVE DRIVE PINION REAR BEARING
SST 09950−00020
SA−109