Toyota Tundra 2005 Service - Repair - Maintenance page 2486

SA−72
INSTALLATION
1. INSTALL UPPER SUSPENSION ARM
Install the upper suspension arm with the 2 washers, bolt and nut.
Torque: 98 N·m (1,000 kgf·cm, 72 ft·lbf)
HINT:
After stabilizing the suspension, torque the nut.
2. INSTALL BRAKE AND FUEL LINE CLAMP
Torque: 5.5 N·m (56 kgf·cm, 49 in.·lbf)
3. INSTALL REAR FENDER APRON SEAL
4. CONNECT UPPER BALL JOINT
(a) Connect the upper ball joint to the upper suspension arm.
(b) Install the nut and a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
Torque: 105 N·m (1,100 kgf·cm, 77 ft·lbf)
5. w/ ABS:
CONNECT ABS SPEED SENSOR WIRE HARNESS CLAMPS
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
6. INSTALL SHOCK ABSORBER WITH COIL SPRING (See page SA−68)
7. CHECK FRONT WHEEL ALIGNMENT (See page SA−5)
SUSPENSION AND AXLE − FRONT UPPER SUSPENSION ARM
SA0AE−05