Toyota Tundra 2005 Service - Repair - Maintenance page 3322

BO-208
BODY
(b)
4.
Install the cup holder with the 4 screws to the center armrest.
H11245
5.
Install the center armrest with the 2 nuts to the seatback assem-
bly.
6.
(a)
(b)
H11518
7.
Install the seatback assembly with the 4 bolts.
8.
Install the seat cushion hinge plate with the 2 nuts to the seat-
back frame.
9.
Install the seat cushion side cover with the screw.
H11243
10.
Hog Ring
(a)
HINT:
When installing the hog rings, take as much care as possible to
prevent wrinkles.
(b)
(c)
H11242
- REAR SEAT (Bench Type)
Install the center armrest hinge cover as shown in the il-
lustration, then perform the same procedure on the other
side.
INSTALL CUP HOLDER
INSTALL CENTER ARMREST
Torque: 21 N·m (215 kgf·cm, 16 ft·lbf)
INSTALL 4 CRS TETHER ANCHOR BRACKETS
Install the CRS tether anchor bracket with the bolt.
Torque: 9.0 N·m (92 kgf·cm, 80 in.·lbf)
Perform the same procedure on the other CRS tether an-
chors.
INSTALL SEATBACK ASSEMBLY
Torque: 21 N·m (215 kgf·cm, 16 ft·lbf)
INSTALL SEAT CUSHION HINGE PLATE
Torque: 21 N·m (215 kgf·cm, 16 ft·lbf)
INSTALL SEAT CUSHION SIDE COVER
INSTALL SEAT CUSHION COVER
Install the seat cushion cover with new hog rings.
Close the fastener.
Perform the same procedure on the other side.
Author : Date :
4979