Toyota Tundra 2005 Service - Repair - Maintenance page 3270

BO-156
Clip
Claws
Claws
BODY
DISASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:
z
The procedures listed below are for the LH side.
z
Tape the screwdriver tip before using it to remove the
parts.
1. REMOVE HEADREST
2. REMOVE SEAT CUSHION OUTER SHIELD
(a) Remove the screw from the seat cushion outer shield.
(b) Using a screwdriver, remove the seat cushion outer
shield.
HINT:
Tape the screwdriver tip before use.
3. REMOVE RECLINING ADJUSTER RELEASE HANDLE
H24331
4. REMOVE VERTICAL ADJUSTER HANDLE
(a) Using a screwdriver, remove the vertical adjuster handle
cap.
HINT:
Tape the screwdriver tip before use.
H24332
(b) Remove the 2 screws and the vertical adjuster handle.
H24333
5. REMOVE SEAT CUSHION INNER SHIELD
(a) Remove the screw from the seat cushion inner shield.
(b) Using a screwdriver, remove the seat cushion inner
shield.
HINT:
Tape the screwdriver tip before use.
6. REMOVE FRONT SEAT INNER BELT
(a) Disconnect the wire harness clamps and connectors.
Clip
(b) Remove the nut and front seat inner belt.
H24334
- FRONT SEAT (Separate Type: Manual Adjuster)
Author :
BO4SD-01
Date :
4927