Toyota Tundra 2005 Service - Repair - Maintenance page 2699

Screw
Extractor
STEERING - STEERING COLUMN (Standard Cab, Access Cab)
DISASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1. REMOVE KEY CYLINDER LAMP ASSEMBLY
Remove the clip and key cylinder lamp assembly.
2. REMOVE COLUMN UPPER BRACKET AND COLUMN
UPPER CLAMP
(a) Using a centering punch, mark the center of the 2 ta-
pered-head bolts.
(b) Using a 3 to 4 mm (0.12 to 0.16 in.) drill, drill a hole into
the 2 bolts.
(c) Using a screw extractor, remove the 2 bolts, column up-
per bracket and column upper clamp.
3. A/T:
F06732
REMOVE SHIFT LEVER
Remove the screw and shift lever.
4. A/T:
REMOVE UPPER NO. 2 STEERING COVER
5. A/T:
REMOVE PARK LOCK CABLE ASSEMBLY
(See page
6. A/T:
REMOVE SHIFT LEVER HOUSING
Remove the 3 torx® screws and shift lever housing.
7. Tilt steering column:
REMOVE RELEASE LEVER SPRING
8. REMOVE TURN SIGNAL BRACKET
F06733
Remove the 2 torx® screws and turn signal bracket.
9. Non-tilt steering column:
REMOVE COLUMN UPPER TUBE WITH MAIN SHAFT
ASSEMBLY
(a) Remove the 4 torx® bolts.
(b) Remove the column upper tube with the main shaft as-
sembly from the column tube assembly.
AT-21 )
Author : Date :
SR-21
SR1KI-02
4347