clear ets counters
Clear all ETS TLV counters on an interface.
S4810
Syntax
clear ets counters port-type slot/port
Parameters
port-type
Defaults
none
Command Modes
EXEC Privilege
Command History
Version 8.3.12.0
Version 8.3.16.0
dcb-enable
Enable data center bridging.
S4810
Syntax
dcb enable
To disable DCB, use the no dcb enable command.
Defaults
none
Command Modes
CONFIGURATION
Command History
Version 8.3.12.0
Version 8.3.16.0
Usage
By default, iSCSI is enabled on the unit and flowcontrol is enabled on all of the interfaces or if
Information
link-level flow control is enabled on one or more interfaces. To enable DCB, do one of the
following:
Related
dcb-policy input
Commands
Enter the keywords port-type followed by the slot/port
information.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
•
Apply the dcb-input policy command with the no pfc-mode command on to
all the interfaces.
•
Disable flow-control on all of the interfaces.
– applies the input policy with the PFC configuration to an ingress interface.
609