Cli Is Not Accessible; Nvram Init - Avaya G350 Installing And Upgrading

Troubleshooting

CLI is not accessible

Check the connectivity to the G350: correct ip address and subnet on the PC attached to the
G350, and the cable. Contact a certified technician if you can't resolve this problem.

NVRAM Init

Perform an NVRAM init only when you cannot access the G350, for example when the G350
resets continuously.
!
Important:
Performing the NVRAM init restores the G350 to its initial state with the default
Important:
settings.
You can perform an NVRAM initialization using a jumper on the G350 motherboard.
VOLTAGE ALERT:
Disconnect the G350 from the external power source before proceeding.
VOLTAGE ALERT:
ELECTROSTATIC ALERT:
Do not touch any components on the printed circuit board except when installing
ELECTROSTATIC ALERT:
or removing the bridge for the jumper pins.
1. Disconnect the cables from the media modules in slots V3, V4 and V5.
2. Disconnect the power cord from the power receptacle on the rear panel of the G350.
3. Remove the G350 from the rack or wall if necessary.
Note:
You do not need to remove the mounting brackets.
Note:
4. Remove the media modules or slot covers from slots V3, V4 and V5.
5. Locate the NVRAM init jumper (jumper JP18) on the front of the G350 motherboard. Refer
to Figure
108 Installation and Upgrades for the Avaya G350 Media Gateway
26.