Protocol Lldp (Interface) - Dell C9000 Series Reference Manual

Version
7.6.1.0
7.4.1.0

protocol lldp (Interface)

Enter the LLDP protocol in INTERFACE mode.
C9000 Series
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp
command from Interface mode.
Defaults LLDP is not enabled on the interface.
Command Modes INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Usage Information Before LLDP can be configured on an interface, it must be enabled globally from
CONFIGURATION mode. This command places you in LLDP mode on the interface; it
does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE mode,
interfaces begin to inherit the configuration from global LLDP CONFIGURATION mode.
Description
Introduced on the C-Series.
Introduced on the E-Series.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link Layer Discovery Protocol (LLDP) 1373