Protocol Lldp (Interface) - Dell S6000 Reference Manual

Command line for the system
Hide thumbs Also See for S6000:
Table of Contents

Advertisement

Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0

protocol lldp (Interface)

Enter the LLDP protocol in INTERFACE mode.
S6000
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp
command from Interface mode.
Defaults
LLDP is not enabled on the interface.
Command
INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Usage
Before LLDP can be configured on an interface, it must be enabled globally from
Information
CONFIGURATION mode. This command places you in LLDP mode on the
interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
906
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link Layer Discovery Protocol (LLDP)

Advertisement

Table of Contents
loading

Table of Contents