Ip Ospf Mtu-Ignore - Allied Telesis x510-28GTX Command Reference Manual

OSPF C
OMMANDS
-
IP OSPF MTU IGNORE

ip ospf mtu-ignore

Overview Use this command to configure OSPF so that OSPF does not check the MTU size
during DD (Database Description) exchange.
Use the no variant of this command to make sure that OSPF checks the MTU size
during DD exchange.
Syntax ip ospf [<ip-address>] mtu-ignore
no ip ospf [<ip-address>] mtu-ignore
Mode Interface Configuration for a VLAN interface.
Usage By default, during the DD exchange process, OSPF checks the MTU size described
in the DD packets received from the neighbor. If the MTU size does not match the
interface MTU, the neighbor adjacency is not established. Using this command
makes OSPF ignore this check and allows establishing of adjacency regardless of
MTU size in the DD packet.
awplus#
Example
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter Description
<ip-address>
IPv4 address of the interface, in dotted decimal notation.
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip ospf mtu-ignore
1015