Storm-Constrain Enable Trap; Storm-Constrain Interval - 3Com S7906E Command Reference Manual

[Sysname-Ethernet2/0/1] undo storm-constrain enable log

storm-constrain enable trap

Syntax
storm-constrain enable trap
undo storm-constrain enable trap
View
Layer 2 Ethernet interface view
Default Level
2: System level
Parameters
None
Description
Use the storm-constrain enable trap command to enable trap message sending. With trap message
sending enabled, the system sends trap messages when traffic reaching a port exceeds the
corresponding threshold or the traffic drops down below the lower threshold after exceeding the upper
threshold.
Use the undo storm-constrain enable trap command to disable trap message sending.
By default, trap message sending is enabled.
Examples
# Disable trap message sending for Ethernet 2/0/1.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] undo storm-constrain enable trap

storm-constrain interval

Syntax
storm-constrain interval seconds
undo storm-constrain interval
View
System view
Default Level
2: System level
Parameters
seconds: Interval for generating traffic statistics, in the range 1 to 300 (in seconds).
1-32