Duplex; Flow-Control - 3Com S7906E Command Reference Manual

Field
Trap
Log
Swi-num

duplex

Syntax
duplex { auto | full | half }
undo duplex
View
Ethernet interface view
Default Level
2: System level
Parameters
auto: Indicates that the interface is in auto-negotiation state.
full: Indicates that the interface is in full-duplex state.
half: Indicates that the interface is in half-duplex state. The optical interface of a Combo port does not
support the half keyword.
Description
Use the duplex command to configure the duplex mode for an Ethernet interface.
Use the undo duplex command to restore the duplex mode for an Ethernet interface to the default.
By default, the duplex mode for an Ethernet interface is auto.
Related commands: speed.
Examples
# Configure the interface Ethernet 2/0/1 to work in full-duplex mode.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] duplex full

flow-control

Syntax
flow-control
undo flow-control
State of trap messages sending. "on" indicates trap message sending is
enabled; "off" indicates trap message sending is disabled.
State of log sending. "on" indicates log sending is enabled; "off" indicates
log sending is disabled.
Number of the forwarding state switching.
This field is numbered modulo 65,535.
1-14
Description