Storm-Constrain - 3Com S7906E Command Reference Manual

configuring speed auto 100 1000 on an interface, the rate is 100 Mbps by force, with no negotiation
performed between the interface and the peer end; if you configure speed auto 100 1000 after
configuring speed 100 on the interface, the rate through negotiation can be either 100 Mbps or 1000
Mbps only.
Note that:
When the auto-negotiation rate ranges set on the local and peer ends do not intersect, for example,
10 and 100 Mbps on one end and 1000 Mbps on the other, the rate negotiation will fail.
When the auto-negotiation rate ranges set on the local and peer ends intersect, for example, 10
and 100 Mbps on one end and 100 and 1000 Mbps on the other, the negotiation rate range is the
intersection, 100 Mbps.
When the auto-negotiation rate ranges set on the local and peer ends are the same, for example,
100 and 1000 Mbps, the maximum value of the auto-negotiation rate is 1000 Mbps.
This function is available for auto-negotiation-capable 100 MB or Gigabit Layer-2 Ethernet
interfaces only. For a Combo port, only the electrical port supports this function.
If you repeatedly use the speed and the speed auto commands to configure the transmission rate
on an interface, only the latest configuration takes effect.
Examples
# Set the auto-negotiation rate of interface GigabitEthernet 2/0/1 to 10 Mbps or 1000 Mbps.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] speed auto 10 1000

storm-constrain

Syntax
storm-constrain { broadcast | multicast } pps max-pps-values min-pps-values
undo storm-constrain { all | broadcast | multicast }
View
Layer 2 Ethernet interface view
Default Level
2: System level
Parameters
all: Disables the storm constrain function for all types of packets (that is, unicast packets, multicast
packets, and broadcast packets).
broadcast: Enables/Disables the storm constrain function for broadcast packets.
multicast: Enables/Disables the storm constrain function for multicast packets.
1-29