3Com S7906E Command Reference Manual page 90

Description
Use the display interface command to display the current state of a specified interface and related
information.
If neither interface type nor interface number is specified, all interface information will be displayed.
If only interface type is specified, then only information of this particular type of interface will be
displayed.
If both interface type and interface number are specified, then only information of the specified
interface will be displayed.
Related commands: interface.
Examples
# Display the current state of Layer 2 interface Ethernet 2/0/1 and related information.
<Sysname> display interface ethernet 2/0/1
Ethernet2/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e200-8048
Description: Ethernet2/0/1 Interface
Loopback is not set
Media type is twisted pair, port hardware type is 100_BASE_TX
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9022
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 100
Mdi type: auto
Link delay is 10(sec)
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 100
Port priority: 0
Last 300 seconds input:
Last 300 seconds output:
Input (total):
0 broadcasts, 0 multicasts
Input (normal):
0 broadcasts, 0 multicasts
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, - bytes
0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 packets, 0 bytes
0 packets, - bytes
-%
-%
1-7