Status View I; Status View; Parameter Setup - Danfoss VLT AutomationDrive FC 301 Programming Manual

VLT AutomationDrive FC 301/302
Programming Guide
Operating variable
Parameter 16-96 Maintenance Word
Parameter 16-97 Alarm Word 3
Parameter 16-98 Warning Word 3

4.1.3.1 Status View I

This readout state is standard after start-up or initialization. Press [Info] to obtain information about the units linked to the shown
operating variables (1.1, 1.2, 1.3, 2 and 3). See the operating variables shown in the following illustration.
S t a tus
799 RPM 7.83 A
1.1
0.000
1.2
53.2 %
Auto Remote Ramping
2
3
1.3
Illustration 10: Status View I
4.1.3.2 Status View II
See the operating variables (1.1, 1.2, 1.3, and 2) shown in the following illustration. In the example, speed, motor current, motor
power, and frequency are selected as variables in the 1
S t a tus
207 RPM 5.25 A
6.9 Hz
1.1
Auto Remote Running
Illustration 11: Status View II
4.1.3.3 Status View III
This state shows the event and action of the smart logic control.
S t a tus
778 RPM 0.86 A
State: 0 off 0 (off)
When: -
Do: -
Auto Remote Running
Illustration 12: Status View III

4.1.4 Parameter Setup

The drive can be used for practically all assignments. The drive offers 2 programming modes:
• Main menu mode
• Quick menu mode
24 | Danfoss A/S © 2022.12
1 (1)
36.4 kW
st
and 2
1 (1)
24.4 kW
1.3
2
1.2
1 (1)
4.0 kW
nd
lines.
How to Program
Unit
hex
hex
hex
AU275636650261en-000101 / 130R0334