Danfoss VLT AutomationDrive FC 301 Programming Manual page 461

VLT AutomationDrive FC 301/302
Programming Guide
12 13 18 19
12 13 18 19
39 42 50 53
Illustration 88: Test Plugs
Select [2] Initialisation to reset all parameter values to default settings, except for: Parameter 15-03 Power Up's, parameter 15-04 Over
Temp's, and parameter 15-05 Over Volt's. The drive resets during the next power-up. Parameter 14-22 Operation Mode also returns to
the default setting [0] Normal operation.
Option Name
[0]* Normal operation
[1] Control card test
[2] Initialisation
[3] Boot mode
[5] Clear service logs
[6] Clear param. log
Parameter 14-24 Trip Delay at Current Limit
Table 719: Parameter 14-24 Trip Delay at Current Limit
14-24 Trip Delay at Current Limit
Default value: 60 s
Conversion index: 0
Danfoss A/S © 2022.12
27 29 32 33 20 37
FC 302
27 32 33 20
FC 301
54 55
FC 301 &
FC 302
Description
Remember to set switches S201 (A53) and S202 (A54) as specified in the parameter description
when performing a control card test. Otherwise, the test fails.
Select this option to perform initialization. This option does not clear the service logs.
Save the log information using MCT 10 Set-up Software before clearing the service logs.
Select this option and perform a power cycle to clear the log.
Parameter type: Range, 0 - 60 s
Data type: Uint8
N O T I C E
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334 | 461
Parameter Descriptions