Danfoss VLT AutomationDrive FC 301 Programming Manual page 128

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 3-09 On Target Time
Table 192: Parameter 3-09 On Target Time
3-09 On Target Time
Default value: 1 ms
Conversion index: -3
This parameter is only available with software version 48.XX
Enter the time for evaluating the on-target window, see also parameter 3-08 On Target Window.
5.4.2 3-1* References
Select the preset reference(s). Select Preset ref. bit 0/1/2 [16], [17], or [18] for the corresponding digital inputs in parameter group
5-1* Digital Inputs.
Parameter 3-10 Preset Reference
Table 193: Parameter 3-10 Preset Reference
3-10 Preset Reference
Default value: 0%
Conversion index: -2
Enter up to 8 different preset references (0–7) in this parameter, using array programming. The preset reference is stated as a per-
centage of the value Ref (parameter 3-03 Maximum Reference). If a Ref
MAX
programmed, the preset reference is calculated as a percentage of the full reference range, that is on the basis of the difference
between Ref and Ref . Afterwards, the value is added to Ref
MAX MIN
[16], [17] or [18] for the corresponding digital inputs in parameter group 5-1* Digital Inputs.
12 (+24V)
Preset 76543210
10101010 29
32
11001100
33
11110000
Illustration 47: Preset Reference
128 | Danfoss A/S © 2022.12
Parameter type: Range, 0 - 60000 ms
Data type: Uint16
N O T I C E
Parameter type: Range, -100 - 100%, Array [8]
Data type: Int16
[P 5-13=Preset ref. bit 0]
[P 5-14=Preset ref. bit 1]
[P 5-15=Preset ref. bit 2]
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
different from 0 (parameter 3-02 Minimum Reference) is
MIN
. When using preset references, select preset reference bit 0/1/2
MIN
Parameter Descriptions
AU275636650261en-000101 / 130R0334