Danfoss VLT AutomationDrive FC 301 Programming Manual page 363

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 12-38 COS Filter
Table 636: Parameter 12-38 COS Filter
12-38 COS Filter
Default value: 0
Conversion index: 0
Change-of-state PCD filters. Sets up a filter mask for each word of process data when operating in COS mode. Single bits in the PCDs
can be filtered in/out.
5.12.5 12-4* Modbus TCP
Parameter 12-40 Status Parameter
Table 637: Parameter 12-40 Status Parameter
12-40 Status Parameter
Default value: 0
Conversion index: 0
This parameter is read-only. It shows the Modbus TCP-specific 16-bit status word.
Table 638: 16-Bit Status Word, Modbus TCP
Bit Description
0 Link status port 1
1 Link status port 2
2 Link speed
3 Link duplex
4 Port 502 communication
5 UNUSED
6 Valid IP address
7 Modbus timeout (30 s)
8 Duplicate IP
9 Register 7 error
10 FTP server
11 HTTP server
12 SMTP server
13 Cable diagnosis
14 Auto crossover
15 IPMG
Danfoss A/S © 2022.12
Parameter type: Range, 0 - 65535
Data type: Uint16
Parameter type: Range, 0 - 0
Data type: Uint16
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
Bit = [0]
Disconnected
Disconnected
0/10 Mbps
Half
No
–
No
No
No
No
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
AU275636650261en-000101 / 130R0334 | 363
Parameter Descriptions
Bit = [1]
Connected
Connected
100 Mbps
Full
Yes
–
Yes
Yes
Yes
Yes
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled