Danfoss VLT AutomationDrive FC 301 Programming Manual page 399

VLT AutomationDrive FC 301/302
Programming Guide
Par. 13-41
Logic Rule Operator 1
Par. 13-40
Logic Rule Boolean 1
Par. 13-42
Logic Rule Boolean 2 . . .
. . .
Par. 13-44
Logic Rule Boolean 3
Illustration 82: Logic Rules
Priority of calculation
The results of parameter 13-40 Logic Rule Boolean 1, parameter 13-41 Logic Rule Operator 1, and parameter 13-42 Logic Rule Boolean 2
are calculated first. The outcome (true/false) of this calculation is combined with the settings of parameter 13-43 Logic Rule Operator
2 and parameter 13-44 Logic Rule Boolean 3, yielding the final result (true/false) of the logic rule.
Parameter 13-40 Logic Rule Boolean 1
Table 681: Parameter 13-40 Logic Rule Boolean 1
13-40 Logic Rule Boolean 1
Default value: Size related
Conversion index: -
Option Name
[0] False
[1] True
[2] Running
[3] In range
[4] On reference
[5] Torque limit
[6] Current limit
[7] Out of current range
[8] Below I low
[9] Above I high
[10] Out of speed range
[11] Below speed low
[12] Above speed high
[13] Out of feedb. range
[14] Below feedb. low
[15] Above feedb. high
[16] Thermal warning
[17] Mains out of range
[18] Reversing
Danfoss A/S © 2022.12
Par. 13-43
Logic Rule Operator 2
. . .
. . .
Parameter type: Option, Array [10]
Data Type: Uint8
Description
st
Select the 1 boolean (true or false) input for the selected logic rule. See parameter 13-01
Start Event and parameter 13-02 Stop Event for more information.
Parameter Descriptions
Setup: 2 setups
Change during operation: True
AU275636650261en-000101 / 130R0334 | 399