Danfoss VLT AutomationDrive FC 301 Programming Manual page 322

VLT AutomationDrive FC 301/302
Programming Guide
Bit Description
8 Drive is tripped.
9 Internal CAN error.
10 Wrong configuration data from PLC.
11 Wrong ID sent by PLC.
12 Internal fault occurred.
13 Not configured.
14 Timeout active.
15 Warning 34, Fieldbus Fault is active.
Parameter 9-63 Actual Baud Rate
Table 558: Parameter 9-63 Actual Baud Rate
9-63 Actual Baud Rate
Default value: [255] No baud rate found
Conversion index: –
This parameter shows the actual PROFIBUS baud rate. The PROFIBUS master automatically sets the baud rate.
Option
[0]
[1]
[2]
[3]
[4]
[6]
[7]
[8]
[9]
[10]
[11]
[255]*
Table 559: Parameter 9-64 Device Identification
9-64 Device Identification
Default value: 0
Conversion index: 0
322 | Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
Name
9,6 kbit/s
19,2 kbit/s
93,75 kbit/s
187,5 kbit/s
500 kbit/s
1500 kbit/s
3000 kbit/s
6000 kbit/s
12000 kbit/s
31,25 kbit/s
45,45 kbit/s
No baud rate found
Parameter type: Range, 0 - 0
Data type: Uint16
Parameter Descriptions
Setup: All setups
Change during operation: True
Description
Setup: All setups
Change during operation:
AU275636650261en-000101 / 130R0334