Danfoss VLT AutomationDrive FC 301 Programming Manual page 359

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[3457] Synchronizing error
[3458] Actual velocity
[3459] Actual master velocity
[3460] Synchronizing status
[3461] Axis status
[3462] Program status
[3464] MCO 302 status
[3465] MCO 302 control
[3466] SPI error counter
[3470] MCO alarm word 1
[3471] MCO alarm word 2
[4029] B-EMF protection log readout
[4280] Safe option status
[4285] Active safe func.
[4521] Status
[4523] Baseline failure
[4590] Stator [%]
[4591] Load [%]
[4592] Sensor 1 [%]
[4593] Sensor 1 [unit]
[4594] Sensor 2 [%]
[4595] Sensor 2 [unit]
[4596] Sensor 3 [%]
[4597] Sensor 3 [unit]
[4598] Sensor 4 [%]
[4599] Sensor 4 [unit]
Parameter 12-23 Process Data Config Write Size
Table 623: Parameter 12-23 Process Data Config Write Size
12-23 Process Data Config Write Size
Default value: 16
Conversion index: 0
Use this parameter to configure the PCD write size in bits. Only values of multiples of 8 are valid.
Danfoss A/S © 2022.12
Parameter type: Range, 8 - 32
Data type: Uint32
Parameter Descriptions
Description
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334 | 359