Danfoss VLT AutomationDrive FC 301 Programming Manual page 323

VLT AutomationDrive FC 301/302
Programming Guide
This parameter is not visible via LCP.
The device identification parameter. The data type is array [n] of unsigned16. The assignment of the 1
shown in the following table.
Index Content
[0] Manufacturer
[1] Device type
[2] Version
[3] Firmware date year
[4] Firmware date month
[5] No. of axes
[6] Vendor specific: PB version
[7] Vendor specific: Database version
[8] Vendor specific: AOC version
[9] Vendor specific: MOC version
Parameter 9-65 Profile Number
Table 560: Parameter 9-65 Profile Number
9-65 Profile Number
Default value: 0
Conversion index: 0
This parameter is not visible via LCP.
This parameter contains the profile identification. Byte 1 contains the profile number. Byte 2 contains the number of the profile.
Table 561: Parameter 9-67 Control Word 1
9-67 Control Word 1
Default value: 0
Conversion index: 0
This parameter accepts the control word from a master class 2 in the same format as PCD 1.
Parameter 9-68 Status Word 1
Table 562: Parameter 9-68 Status Word 1
9-68 Status Word 1
Default value: 0
Conversion index: 0
This parameter delivers the status word for a master class 2 in the same format as PCD 2.
Danfoss A/S © 2022.12
N O T I C E
Parameter type: Range, 0 - 0
Data type: OctetString
N O T I C E
Parameter type: Range, 0 - 65535
Data type: V2
Parameter type: Range, 0 - 65535
Data type: V2
Parameter Descriptions
st
subindexes is defined and
Value
128 (for Danfoss)
1
xxyy
yyyy
ddmm
Variable
xxyy
xxyy
xxyy
xxyy
Setup: All setups
Change during operation:
Setup: All setups
Change during operation:
Setup: All setups
Change during operation:
AU275636650261en-000101 / 130R0334 | 323