Danfoss VLT AutomationDrive FC 301 Programming Manual page 362

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 12-32 Net Control
Table 631: Parameter 12-32 Net Control
12-32 Net Control
Default value: [0] Off
Conversion index: –
Shows the control source in instance 21/71.
Option
[0]*
[1]
Parameter 12-33 CIP Revision
Table 632: Parameter 12-33 CIP Revision
12-33 CIP Revision
Default value: Size related
Conversion index: 0
This parameter is read-only. It shows the CIP version of the option software.
Parameter 12-34 CIP Product Code
Table 633: Parameter 12-34 CIP Product Code
12-34 CIP Product Code
Default value: Size related
Conversion index: 0
This parameter is read-only. It shows the CIP product code.
Parameter 12-35 EDS Parameter
Table 634: Parameter 12-35 EDS Parameter
12-35 EDS Parameter
Default value: 0
Conversion index: 0
This parameter is used to configure the drive via DeviceNet and build the EDS-file.
Parameter 12-37 COS Inhibit Timer
Table 635: Parameter 12-37 COS Inhibit Timer
12-37 COS Inhibit Timer
Default value: 0
Conversion index: 0
Read-only change-of-state inhibit timer. If the option is configured for COS operation, this inhibit timer can be configured in the
forward open telegram to prevent that continuously changing PCD data generates extensive network traffic. The inhibit time is in
ms. 0 = disabled.
362 | Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
Name
Off
On
Parameter type: Range, 0 - 65535
Data type: Uint16
Parameter type: Range, 0 - 65535
Data type: Uint16
Parameter type: Range, 0 - 0
Data type: Uint32
Parameter type: Range, 0 - 65535
Data type: Uint16
Setup: 2 setups
Change during operation: True
Description
Setup: 1 setup
Change during operation: True
Setup: 1 setup
Change during operation: True
Setup: All setups
Change during operation:
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334
Parameter Descriptions