Danfoss VLT AutomationDrive FC 301 Programming Manual page 222

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[0] No operation
[45] Bus ctrl.
[48] Bus ctrl., timeout
[51] MCO controlled
[97] Reference after ramp
[99] Virtual master speed
[100] Output frequency
[101] Reference
[102] Feedback
[103] Motor current
[104] Torque rel to limit
[105] Torque related to rated
[106] Power
[107] Speed
[108] Torque
[109] Max out freq
[119] Torque % lim
Parameter 5-62 Pulse Output Max Freq #27
Table 376: Parameter 5-62 Pulse Output Max Freq #27
5-62 Pulse Output Max Freq #27
Default value: Size related
Conversion index: 0
Set the maximum frequency for terminal 27 corresponding to the output variable selected in parameter 5-60 Terminal 27 Pulse Out-
put Variable.
222 | Danfoss A/S © 2022.12
Description
Select the display output for terminal 27.
This option is only available with software version 48.XX.
Actual speed reference after the ramp. Use this output as master signal for speed synchroni-
zation of follower drives. The reference is set in parameter 16-48 Speed Ref. After Ramp [RPM].
This option is only available with software version 48.XX.
Virtual master signal for controlling the speed or position of the followers.
Parameter type: Range, 0 - 110000 Hz
Data type: Uint32
N O T I C E
N O T I C E
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334
Parameter Descriptions